Earthway 2150 Commercial Broadcast Spreader User Manual download pdf (Page 2)

Gearbox & Axle Assembly

Drive wheel side

Coast wheel side

Frame brace

1/4-20 x 1-1/2”

Hex Head Bolt

1/4-20 x 2-1/4”

Hex Head Bolt

1/4-20 Locknut

Impeller

Cross Brace

Dimples

Frame

Lower Handle

Pivot Rod

Shut-Off

Step 6B

Step 6C

Step 6A

1/4-20 x 1-1/2”

Flat Head Screw

3. Install impeller onto pinion shaft. Insert 1/8”x 1¼” cotter pin

through impeller then through pinion shaft. Use hole closest to the

gear box. Spread cotter pin to prevent from falling out. Next insert

Cross Brace thru the Gearbox Brace as shown above.

Pinion

Shaft

1/8 x 1-1/4”

Cotter Pin (#36105)

DRIVE WHEEL

HOLE

COAST WHEEL

HOLE

Impeller

Cross Brace

Gearbox & Axle Assembly

Gearbox Brace

Gearbox

FRONT

4. Install gear box by inserting the pinion shaft into hole in

center of hoppers bottom. The word “FRONT” on the gearbox

must point to Front of the hopper. Follow label instructions on

hopper.

Axle Bearing

Flat

Side

Notch

5. Install axle bearings to both lower handles.

NOTE: Notch on bearings and lower

handles. Bearings must go through at side of

lower handle.

6. A - Install lower handles onto axle to both sides as shown. Insert 2¼” bolt through second

hole in lower handle and through rst hole in frame install locknut. DO NOT TIGHTEN.

B - Now insert 1½” bolt through rst hole in lower handle. Then through frame brace.

NOTE: Dimples on frame brace must be facing toward gear box as shown. Next into threaded

connector in cross brace. DO NOT TIGHTEN.

C - Next insert 1½” bolt through other end of frame brace and through second hole in frame

install locknut.

NOW GO BACK AND TIGHTEN ALL NUTS AND BOLTS STARTING WITH FIRST STEP.

DO NOT OVER TIGHTEN.

PAGE 2

1 2 3 4 5 6

Comments to this Manuals

No comments

Earthway 2150 Commercial Broadcast Spreader User Manual Page 2

Comments to this Manuals

Related products and manuals for Gardening equipment Earthway 2150 Commercial Broadcast Spreader