Earthway 2170T Commercial Tow Broadcast Spreader User Manual download pdf (Page 2)

FRONT

Gearbox &

Axle Assembly

Drive wheel

side

Coast wheel

side

Frame brace

1/4-20 x 1½”

Hex Head Bolt

Step 6B & 6C

1/4-20 x 2¼”

Hex Head Bolt

Step 6A

1/4-20 Locknut

Impeller

Cross Brace

Dimples

Frame

Lower Handle

Pivot Rod

Shut-Off

1/4-20 x 1½”

Pan Head Bolt

3. Install impeller onto pinion shaft. Insert 1/8”x 1¼” cotter pin through

impeller then through pinion shaft. Use hole closest to the gear box. Spread

cotter pin to prevent from falling out. Next, insert the Cross Brace into the

Gearbox Brace.

Pinion

Shaft

⅛ x 1¼”

Cotter Pin (#36105)

DRIVE WHEEL

HOLE

COAST WHEEL

HOLE

Impeller

Cross Brace

Gearbox & Axle Assembly

Gearbox Brace

Front

4. Install gear box by inserting the pinion shaft into hole in center of

hoppers bottom. The word “FRONT” on the gearbox must point to

Front of the hopper. Follow label instructions on hopper.

Axle Bearing

Flat

Side

Notch

5. Install axle bearings to both lower

handles. NOTE: Notch on bearings and

lower handles. Bearings must go through

at side of lower handle.

6. A - Install lower handles onto axle

to both sides as shown. Insert 2¼” bolt

through second hole in lower handle and

through rst hole in frame install locknut.

DO NOT TIGHTEN.

B - Now insert 1½” bolt through rst hole in lower handle. Then through frame brace. NOTE: Dimples on frame brace must be facing

toward gear box as shown. Next into threaded connector in cross brace. DO NOT TIGHTEN.

C - Next insert 1½” bolt through other end of frame brace and through second hole in frame install the second cross brace - this one has a

cross hole in the center of the tube.

PAGE 2

1 2 3 4 5 6

Comments to this Manuals

No comments

Earthway 2170T Commercial Tow Broadcast Spreader User Manual Page 2

Comments to this Manuals

Related products and manuals for Gardening equipment Earthway 2170T Commercial Tow Broadcast Spreader